Archos101it

Differences between revisions 2 and 3
Revision 2 as of 2011-04-22 12:15:23
Size: 1061
Editor: 188-22-146-173
Comment:
Revision 3 as of 2011-04-22 12:19:33
Size: 1818
Editor: 188-22-146-173
Comment:
Deletions are marked like this. Additions are marked like this.
Line 22: Line 22:
== Configure ==
The better part of [[ARM/n900]] also applies for the Archos 10.1.

=== USB Networking ===
 * In the device's /etc/network/interfaces
{{{
auto usb0
iface usb0 inet static
 pre-up rmmod musb_hdrc
 pre-up modprobe musb_hdrc mode_default=2
 pre-up modprobe g_ether
 address 192.168.0.202
 netmask 255.255.255.0
 network 192.168.0.0
 gateway 192.168.0.200
}}}
 * In the host's /etc/network/interfaces
{{{
auto usb0
iface usb0 inet static
 address 192.168.0.200
 netmask 255.255.255.0
 up iptables -A POSTROUTING -t nat -s 192.168.0.0/24 -j MASQUERADE
 up echo 1 > /proc/sys/net/ipv4/ip_forward
        down iptables -D POSTROUTING -t nat -s 192.168.0.0/24 -j MASQUERADE
 down echo 0 > /proc/sys/net/ipv4/ip_forward
}}}

photo.jpg

Install Kubuntu on Archos 10.1 internet tablet

  • Install SDE firmware (see archos.com)
  • Generate a kubuntu mobile img using rootstock

sudo rootstock --fqdn archos --login u --password u --keepimage --imagesize 1500M --seed kubuntu-mobile --
dist maverick
  • Mount the rootfs.img of the SDE from your data partition (that is the thing you can mount when doing the USB sharing dance with Android)
  • Mount your Kubuntu .img
  • copy /lib/modules/* from the former to the latter
  • Unmount both (best also run sudo sync)
  • Move the SDE rootfs.img out of the way
  • Copy your Kubuntu .img as new rootfs.img on the data partition
  • sudo sync; unmount and power off the device
  • Power on and hold volume down pressed until the recovery boot thing comes up
  • Select developer edition using the volume button and confirm using the power button
  • If all goes fine you should get to either KDM or TTY login
  • To power off again you'll need to reset by keeping the power button pressed for 10 seconds

Configure

The better part of ARM/n900 also applies for the Archos 10.1.

USB Networking

  • In the device's /etc/network/interfaces

auto usb0
iface usb0 inet static
        pre-up rmmod musb_hdrc
        pre-up modprobe musb_hdrc mode_default=2
        pre-up modprobe g_ether
        address 192.168.0.202
        netmask 255.255.255.0
        network 192.168.0.0
        gateway 192.168.0.200
  • In the host's /etc/network/interfaces

auto usb0
iface usb0 inet static
        address 192.168.0.200
        netmask 255.255.255.0
        up iptables -A POSTROUTING -t nat -s 192.168.0.0/24 -j MASQUERADE
        up echo 1 > /proc/sys/net/ipv4/ip_forward
        down iptables -D POSTROUTING -t nat -s 192.168.0.0/24 -j MASQUERADE
        down echo 0 > /proc/sys/net/ipv4/ip_forward

ARM/Archos101it (last edited 2011-04-22 12:38:20 by 188-22-146-173)