BootDegradedRaid

Differences between revisions 6 and 7
⇤ ← Revision 6 as of 2008-05-30 20:09:31 →
Size: 1696
Editor: 70-2-70-49
Comment: added rationale
← Revision 7 as of 2008-05-30 20:26:25 → ⇥
Size: 2292
Editor: 70-2-70-49
Comment: added use case
Deletions are marked like this. Additions are marked like this.
Line 22: Line 22:
 * Software RAID is often a less expensive alternative to Hardware RAID, and is always available on any Ubuntu system with multiple disk devices
  * This is particularly useful on low-end and small-form-factor servers without built-in Hardware RAID, such as blades and 1-U rack mount systems
 * RAID1 (mirroring) is currently a convenient mechanism for providing runtime failover of hard disks in Ubuntu
 * Remotely administered systems where the owners have taken the initiative to use dedundant disks in a RAID1 configuration expect to be able to boot even after a RAID degradation event

Summary

This specification defines a methodology for enhancing Ubuntu's boot procedures to configure and support booting a system dependent on a degraded RAID1 device.

Rationale

Ubuntu's installer currently supports installation to software RAID1 targets for /boot and /. When one of the mirrored disks fails, and mdadm marks the RAID degraded, it becomes impossible to reboot the system in an unattended manner.

Booting Ubuntu with a failed device in a RAID1 will force the system into a recovery console.

In some cases, this is the desired behavior, as a local system administrator would want to backup critical data, cleanly halt the system, and replace the faulty hardware immediately.

In other cases, this behavior is highly undesired--particularly when the system administrator is remotely located and would prefer a system with redundant disks tolerate a failed device even on reboot.

Use Cases

  • Software RAID is often a less expensive alternative to Hardware RAID, and is always available on any Ubuntu system with multiple disk devices
    • This is particularly useful on low-end and small-form-factor servers without built-in Hardware RAID, such as blades and 1-U rack mount systems
  • RAID1 (mirroring) is currently a convenient mechanism for providing runtime failover of hard disks in Ubuntu
  • Remotely administered systems where the owners have taken the initiative to use dedundant disks in a RAID1 configuration expect to be able to boot even after a RAID degradation event

Scope

Design

Implementation

Outstanding Issues

BoF agenda and discussion

References

BootDegradedRaid (last edited 2010-04-21 10:02:37 by 188-194-18-172-dynip)