DebuggingKernelSuspend

Differences between revisions 13 and 14
Revision 13 as of 2007-10-28 17:36:06
Size: 3935
Editor: 12
Comment:
Revision 14 as of 2007-11-11 09:08:16
Size: 4061
Editor: grmarkham
Comment:
Deletions are marked like this. Additions are marked like this.
Line 17: Line 17:

[What value does one set this back to at the end? tune2fs doesn't seem to have a "list current parameters" option -- Gerv]

Introduction

This page describes how to debug Suspend to RAM/Resume problems on your computer. Do not confuse this with Suspend to disk. ["UnderstandingSuspend"] may have useful background information on where problems can occur.

Suspend and Resume use facilities within your BIOS called ACPI, or Advanced Configuration and Power Interface. Linux provides an ACPI subsystem that manages the suspend and resume process. The usual problem occurs when resuming, and normally the culprit is a device driver that does not recover from a powered down state. If your computer successfully performs a suspend, then it is quite likely any resume problems are due to another device driver and not the ACPI subsystem.

The debugging procedure described below requires a linux kernel 2.6.20 (and newer) for the ability of "/sys/power/pm_trace". Currently (Mar 2007), FeistyFawn is the only ubuntu release that has a new enough kernel, as EdgyEft uses 2.6.17. You can check the version of the kernel you are running by uname -r from a terminal. You can also just look in the directory /sys/power/ (from a terminal type ls /sys/power/) to see if a file called pm_trace exists; it will only do so if the kernel supports the following debugging procedure.

Debugging procedure

Resume problems are difficult to debug since there is no non-volatile storage available at the time resume is bringing up your computer. The only hardware on a PC motherboard that retains information across power cycles is the real time clock (RTC). For those that just have to know, read Documentation/power/s2ram.txt in your kernel sources. The implementation of suspend/resume debug trace is in drivers/base/power/trace.c.

Caveat Emptor: Using the following debug suggestions will radically change the values in your RTC chip, so much so that your file system will think it has been eons since the last fsck. You can avoid a long fsck delay by using 'tune2fs'. For example, 'tune2fs -i 0 /dev/sda1' disables fsck on boot.

[What value does one set this back to at the end? tune2fs doesn't seem to have a "list current parameters" option -- Gerv]

NTP is not sufficient to recover the correct time of day. By default NTP is configured to to only correct for about an hour drift. You must use the 'date' command to get the RTC value within the drift tolerance.

In order to stimulate your suspend/resume process, enter the following commands (as root):

{{{sync; echo 1 > /sys/power/pm_trace; /etc/acpi/sleep.sh force }}}

At this point your computer should enter the suspend state within a few seconds. Usually the power LED will slowly flash when in the suspended state. When that has happened, initiate the resume process by pressing the power button. Observe closely if the disk light comes on briefly. This indicates that resume has begun. If resume fails to complete, then press the power button until the computer turns off. Power on your computer making sure that it loads the same kernel that exhibited the resume problem. You have about 3 minutes to start this boot process before the information saved in the RTC gets corrupted.

Start a console and enter:

{{{dmesg > dmesg.txt }}}

You can edit this file and find line similar to these:

{{{[ 11.323206] Magic number: 0:798:264 [ 11.323257] hash matches drivers/base/power/resume.c:46 }}}

There may well be another 'hash matches' line beyond that. If so, then you are in luck because the last one is the likely culprit. For example:

{{{hash matches device i2c-9191 }}}

The only way to prove this is to remove the module prior to initiating suspend. Repeat as needed...


Also see:


CategoryBugSquad

DebuggingKernelSuspend (last edited 2019-01-28 21:01:56 by penalvch)