UMEdesktop-power
Differences between revisions 3 and 4
2015
Comment: converted to 1.6 markup
|
2036
|
Deletions are marked like this. | Additions are marked like this. |
Line 5: | Line 5: |
|| Last Version these cases were run against|| || '' ex. UME 8.04 '' || |
|| Build tested || Tester || Date || Pass/Fail || Bug # || Comment || || || || || || || || |
Advanced Power Management
Build tested |
Tester |
Date |
Pass/Fail |
Bug # |
Comment |
|
|
|
|
|
|
ACPI Status
Collect information on ACPI status
- Run the following command for device information
acpi -V
- Run the following command for version information
acpi -v
S-State
Confirm the following state is supported
- Suspend to RAM, resume and check the keyboard, mouse, touchpad, video, USB, CDROM and network;
- Suspend to Disk, resume and check the keyboard, mouse, touchpad, video, USB, CDROM and network.
C-state
Confirm the following state is supported
- The every supported C-states can be entered on UP
- The every supported C-states can be entered on SMP.
- The C-states when AC adapter and battery are as power supplier
- The C-states change when switching between AC and Battery
P-state
Confirm the following state is supported
- Verify the performance governor: set to performance governor and check the frequencies of all the CPUS. It should be the maximum supported freq.
- Verify the powersave governor: set to powersave governor and check the frequencies of all the CPUS. It should be the minimum supported freq.
- Verify the userspace governor: set to userspace governor and make sure, that it is set properly; set to all possible frequencies and check whether it is set properly.
- Verify that the on-demand governor obeys the scaling max and min frequencies: set to ondemand governor and make sure it is set properly; Take all CPUs to idle and make sure the frequencies goes to the minimum; Keep all CPUs busy and make sure freq goes to the maximum.
T-state
Confirm the following state is supported
- T-state performance: observe any performance differences through the /sys/devices/system/cpu/cpu*/cpufreq/stats and /proc/acpi/processor/*/power during controlled workloads.
Testing/Cases/UMEdesktop-power (last edited 2009-02-06 08:44:10 by port-213-160-23-156)