NtrigFirmwareStatus
Observed by |
On |
Win |
Firmware |
Win driver |
Software bundle |
Behaviour |
Default descriptors |
Analysis |
Rafi Rubin |
xt |
|
3.2.11.3.5 |
1.23 |
|
Pen, no multitouch |
not available |
|
Olivier Thauvin |
xt2 |
|
3.5.5.13.5 |
1.26 |
1.88 |
Pen, some multitouch |
no multitouch in reports |
|
Stephane Chatty |
tx2 |
7000 |
3.5.8.8.5 |
1.26 |
8.18 |
pen, no multitouch |
no multitouch in reports |
|
Pascal Giard |
tx2 |
Vista |
3.5.9.8.5 |
1.26 |
1.89 |
Pen, some multitouch |
|
|
Stephane Chatty |
tx2 |
7000 |
4.2.17.8.5 |
1.26 |
8.18 |
no pen, multitouch |
multitouch visible in reports |
|
Rafi Rubin |
xt |
7100 |
4.3.6.3.5 |
1.26 |
2.59 |
Pen/multitouch |
|
Evidence of mode switching |
Stephane Chatty |
tx2 |
7100 |
4.3.6.8.5 |
1.26 |
2.59 |
Pen/multitouch |
Evidence of mode switching |
|
Thomas Hansen |
|
|
4.3.6.13.5 |
1.26 |
2.59.0 |
|
|
|
Stephane Chatty |
tx2 |
7000 |
4.5.31.8.5 |
|
2.184 |
both pen and multitouch, 3 modes |
|
|
dragon788 |
xt3 |
7000 |
1.4.11.41.0 |
|
|
pen, no multitouch |
|
shows up as input5,input6,input7 under hiddev,hidraw0/input0 device and nothing under input,hidraw1/input1 |
Q: How do you get this info?
Boot Windows 7, launch the N-trig control panel and read the firmware version from its main page.
In Maverick (10.10), firmware version is printed on driver load:
[ 22.808279] ntrig 0003:1B96:0001.0001: hidraw0: USB HID v1.10 Device [N-trig DuoSense] on usb-0000:00:14.5-2/input0
[ 22.811262] ntrig 0003:1B96:0001.0001: Firmware version: 4.6.5.8.5 (1808 05a1)
Q: How does one get the output shown in the 'default descriptors' column?
Multitouch/NtrigFirmwareStatus (last edited 2012-06-14 00:17:20 by dragon788)